When installing a door, the first thing you need to do is to measure the height and width of the opening. Although the height is an important factor in the case of an internal door, you need to be very careful while measuring for your input. For the width, you must keep in mind that it will be different in the middle, bottom and top.
Once the measurement is made, you will need to remove the hinges of the old, for Relocation. Now install the new hinge leaf in your doorframe. You can use a circular saw to cut the unit according to the required width. It is best to use a saw guide to get a precise cut.
During the installation of the door, remember also to place blocks on the floor under the appliance. In the opening only one sheet of the new hinge will be attached to the doorframe. Make sure the barrel of the hinges facing you.
Image Source: Google
You will need to repeat the same process on the side of the latch your input. Once you have placed your device in its exact location, mark the top and bottom of the hinge with a pencil.
You will need a gauge butt to set the location of the hinge. Now place your device into the opening and reach the leaves of the hinges. Finally compressing the pin in the barrel.