At the end of the swimming, the season is advised to follow the closure of the procedure, to protect the pool and equipment, and also to make it easier to open in the spring. ,

Winterization procedure

Remove the solar cover to protect from frost and ice. Wash thoroughly, fold or roll, and store it in a clean, dry. You can get solar cover via

Solar blankets are vulnerable to attack by chlorine so the cover must be washed before storing for the winter. Each roll had to be moved indoors if possible if not, fitting Storage Reel Cover will offer some protection.

Image result for pool cover

Image Source: Google

Use a pool brush to clean the entire surface of the pool and then remove dirt and debris, such as leaves, with skimming nets, and finally vacuum the pool. Dirt left in the water is a common cause of algae growth. To avoid this, make sure it is removed now.

Adjust the pH to between 7.2 and 7.6 and doses using Chlorine Shock Granules. The effectiveness of chlorine can be quickly reduced if the pH is out of range. A good dose of chlorine at the end of the summer will help to prevent the growth of algae during the period close down.

Next to be sure to add the correct dose of winter Algaecide, to keep the water clear over the winter. Use either a longer life algaecide one or standards.

Long-life covered only once, but more expensive, while the standards need to be added every 2 weeks. You need to use specialist Winter Algaecide, rather than a summer one, which does not contain any flocculants.

Its spring time and many homeowners have started to think about opening up their pools for the season. Did you know that a solar pool cover can actually allow you to use your pool earlier in the year and use it well into the chilly months?

If you live in a sunny place, this could be a good way to get more from your pool, begin harnessing the sun's energy, and move green!

If you want to buy solar pool covers then you can simply visit

Swimming Pool Covers

These pool covers have two features that allow operating efficiently. To begin with, they absorb the sun's warmth and rays with a system of air pockets.

These pockets seem to be very much like the bubble wrap you use for protecting valuable items when going. The air and plastic bubbles absorb heat from sunlight and transfer it into the water via an efficient bottom layer.

The bottom layer also performs the next function of the cover. This coating acts as a sort of a one-way street, allowing heat from the exterior while trapping the heat that is from the water. This is done with a space-age, UV-resistant material. This way the warmth that is already in your water does not escape.

They are able to do it in a few ways. Most importantly they lower the usage of gas or electricity to heat water. By trapping the heat in the water and adding heat to the water when the sun shines, the cover lowers the work that the existing heater has to do.